Material Type
Certificate Details
Naval certificates: in Size and Alloy, use a | symbol to split the value onto two lines in the cell (e.g. "500x1350x5MM - 1 Nos | 1250x1400x5MM - 1 Nos").
1Dimensional Properties
OD (Outer Diameter)
Width
Thickness
Length (optional)
Camber in mm/mtr MAX (optional)
2Mechanical Properties
Hardness in VPN · IS 1501 : 2020
Grain Size in mm · IS 4748 : 1988
Tensile Strength in N/mm² · IS 1608 : 2022
Elongation % per 50mm · IS 1608 : 2022
Yield Strength — naval: (0.2% offset) MPa
Yield Strength (0.5% extention under load) MPa
Bend Test (Transverse/Longitudinal) · IS 1599 : 2023
Electrical Resistivity (ohm/mm²/m) · IS 3635 : 1968
Electrical Conductivity (% IACS) · IS 3635 : 1968
Erichen Value (mm)
R.A Value (um)
Surface Finish (Visual)
These certificates print 3 Observed sample columns. Fill only Observed 1 and the same value repeats in all three columns.
Tolerance, Grain Size and Bend Test fields left blank print their defaults: (+/- 0.1), (+/- 0.02), N/A, PASS, OK.
3Chemical Composition (% by weight)
Copper (Cu)
Lead (Pb)
Tin (Sn)
Iron (Fe)
Zinc (Zn)
Bismuth (Bi)
Total Impurities
Remarks (printed below the tables)
One numbered point per line. Standard lines are pre-filled when you switch to Naval — edit lot-specific details in point 1.
BIS Certification Line
Prints as: "Certified that the sample of a specimen of [Material] is as per specification under BIS certificate licence No. 9100206810 as per [Standard], dated 11/10/2024." Licence no. and date are fixed; leave fields blank for the defaults shown.